Little Wonder 2119 19 - Manual (Page 4)

A. Safety Decals
An important part of the safety system incorporated in this
trimmer are the warning and information decals found on
various parts of the trimmer. These decals must be replaced in
time due to abrasion, etc. It is your responsibility to replace the
decals when they become hard to read. The location of these
decals and their part numbers for ordering are shown below.
B. General Safety Rules
1. THIS MACHINE CAN CAUSE SERIOUS INJURIES. Read
the instructions carefully for the correct handling, preparation,
maintenance, starting and stopping of the machine. Be familiar
with all controls and the proper use of the machine. Pay
particular attention to all sections regarding safety.
2. Always keep a firm grip on both handles while the blades
are moving and/or the engine is running. On double edge units
one hand grasps the front loop handle, while the other hand
grasps the rear handle. On single edge units the right hand
grasps the front side handle and the left hand grasps the rear
handle. BE AWARE!! The blades coast after throttle trigger
is released or engine is switched off. Make sure blades have
come to a complete stop and engine is off before releasing a
handle.
3. Maintain a firm footing and good balance, do not overreach
while trimming. Before you start to trim, check the work area
for obstacles that might cause you to lose your footing, balance
or control of the machine. While operating the machine always
be sure of a safe and secure operating position especially when
using steps or a ladder.
4. Keep area clear of children, pets, and bystanders.
5. Blades coast after throttle trigger is released or engine is
switched off.
6. Stop the engine before checking, maintenance or working
on the machine.
7. Never operate without guards, handles and safety devices
in place.
8. Never attempt to use an incomplete machine or one fitted
with an unauthorized modification.
9. To reduce fire hazard, keep engine and silencer free of
debris, leaves, or excessive lubricant.
10. Know how to stop the machine quickly in an emergency.
WARNING - DANGER
IMPROPER USE OR CARE OF THIS TRIMMER,
OR FAILURE TO WEAR PROPER PROTECTION
CAN RESULT IN SERIOUS INJURY.
READ AND UNDERSTAND THE RULES FOR
SAFE OPERATION AND ALL INSTRUCTIONS
IN THIS MANUAL.
WEAR HEARING PROTECTION.
WARNING! WEAR EYE AND EAR
PROTECTION
READ AND UNDERSTAND
OWNER’S MANUAL BEFORE
USING! KEEP IN SAFE PLACE!
CUTTING HAZARD! KEEP BOTH
HANDS ON HANDLES AND
AWAY FROM BLADES!
EAR/ EYE
PROTECTION
LABEL P/N 4036
LITTLE WONDER
LABEL P/N 357
MUFFLER
LOCKOUT
TRIGGER
STOP
SWITCH
THROTTLE
TRIGGER
REAR
HANDLE
FUEL TANK CAP
GEAR HOUSING
WARNING LABEL P/N 300605
MODEL NO. LABEL
FRONT SIDE HANDLE
ADJUSTING
SCREW AND
BLADE GUARD
FRAME
BAR
STARTER HANDLE
SPARK PLUG WIRE
THROTTLE CABLE
PRIMER BULB
AIR CLEANER
CHOKE KNOB
CUTTING
BLADES
MUFFLER
FUEL TANK CAP
SERIAL NO.
LOOP HANDLE
CHOKE
KNOB
CUTTING
BLADES
FRAME BAR
ADJUSTING
SCREW & NUT
SAFETY COMB
STARTER HANDLE
AIR CLEANER
GEAR HOUSING
THROTTLE TRIGGER
REAR HANDLE
LOCK OUT TRIGGER
STOP SWITCH
WARNING SYMBOLS
PRIMER BULB
SPARK PLUG WIRE
4
Safety and Warnings
WARNING - DANGER
IF TRIMMER IS USED IMPROPERLY OR SAFETY
PRECAUTIONS ARE NOT FOLLOWED. THE
USER RISKS SERIOUS INJURY TO
THEMSELVES AND OTHERS.
READ AND UNDERSTAND THE FOLLOWING
BEFORE ATTEMPTING
TO OPERATE THIS HEDGE TRIMMER