LaCie LaPlug - Manual (Page 5)

Installation
Note: If you want to turn off the drive, press and hold the power button for 5 seconds until
the LED blinks blue. When the LED turns off, the drive has shut down.
2. Connect the power supply.
4. Install and run LaCie Network Assistant,
located on the CD-ROM.
1. Connect the Ethernet cable to the
product and to your local network
(network hub, switch, or router).
Router or Hub
IN OUT
3. Push the power button until the front
LED blinks blue. Release the button
and the product will boot, which
may take up to two minutes. When
the light becomes steady blue, the
product is ready to use.
Fig. 1
Fig. 2
Fig. 3