Lennox Hearth CAMBRIA 850 - Manual (Page 25)

CLEARANCE TO COMBUSTIBLES
The following clearances meet the minimum requirements for a safe
installation:
• Side wall (fireplace front): 24” (457 mm) measured from the fireplace
door.
• Ceiling: 7’ 6” (2286 mm) measured from the base of the fireplace
• Fireplace enclosure:
Bottom: 0”
Side: 0” to spacer
Back: 0” to spacer
Top: Do not fill the space above the fireplace with any material
(Except the wood framing. See Figure 15)
• Chimney: 2” (50 mm)
• Mantel: 59” (1422 mm) measured from the base of the fireplace.
SPECIFICATIONS REPLACEMENT PARTS LIST
Cat. No. Model
H6998 Cambria
Product Reference Information
Weight w/ crate 675 lbs
Weight w/out crate and
refractory bricks
500 lbs
Height 59” (1499mm)
Width 48-1/2” (1232mm)
Depth 29” (737mm)
Chimney weight ASHT+ (10” dia.) 8-1/2 lb/ft.
Chimney weight AC (10” dia.) 4 lb/ft
Cambria™ - Replacement Parts
Description Cat./Part No.
Front Edge Refractory Brick PR-SR2693
Back Refractory Brick PR-SR2821
Right Side Refractory Brick PR-SR2823
Left Side Refractory Brick PR-SR2822
Bottom Refractory Brick PR-SR2692
Wooden Door Handle PR-SR2722
Decorative Screw Caps (2) PR-SACBTFBK2
Ceramic Glass (1) PR-SR2677
Andiron (2) PR-SR2824
Black Metallic Paint “Forrest Paint” Can H8159
Door Gasket: 58-3/4” 5/8” Dia., (order 1 per door) PR-SR1823N
Right Door Assembly PR-SR2678
Left Door Assembly PR-SR2679
Finishing Facade PR-SR2701
Door Lock Tab PR-SR2715
Bearing PR-SR2674
Chimney Damper Control Handle And Rod PR-SR2762
Chimney Damper Plate And Pivot Rod PR-SR2665
Fire Screen PR-SR2723
Fire Screen Support Rod PR-SR2779
Left Slider Assembly PR-SR2680G
Right Slider Assembly PR-SR2680D
Slider Stopping Plate PR-SR2714
Right Hinge PR-SR1800DLV
Left Hinge PR-SR1800GLV
Fireplace Top Panel PR-SR2661
Fireplace Left Side Panel PR-SR2659
Fireplace Right Side Panel PR-SR2660
Fireplace Back Panel PR-SR2658
Contact an Authorized Lennox Hearth Products dealer to obtain any of
these parts. Never use substitute materials not approved by Lennox
Hearth Products. Use of non-approved parts can result in poor perfor-
mance and safety hazards.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
25