Loewe 32959022 - Manual (Page 5)

5 -
Connections rear side of the device
(1 Digital twin satellite tuner optionally available as an retrofit kit (see accessories, page 58).
ANT OUT
Connect antenna
output with ANT-TV
(tuner 1)
ANT-TV
Antenna/cable
analogue/digital
(Tuner 1)
mains switch
CONTROL - rotating stand control
RS-232C - serial interface
AUDIO IN1 L/R - audio input left/right (analogue)
AUDIO OUT L/R - audio output left right (analogue)
ANT SAT2 (1
Satellite antenna
(Sat tuner 2)
ANT2
Antenna/cable
analogue/digital
(Tuner 2)
AV1
Euro-AV
socket 1
AV2 (RGB)
Euro-AV
socket 2
220-240V~ 50/60Hz
mains connection
SERVICE - service socket
PC IN - VGA-/XGA input
HDMI2 - HDMI (DVI) input 2
AUDIO DIGITAL IN - digital audio input
AUDIO DIGITAL OUT - digital audio output
SD/HD-COMPONENT IN Cb/Pb–Cr/Pr–Y - component video inputs
Headphones
connection
Common Interface 1
(CI-Slot 1)
S-VHS connection (AVS)
(e.g. for camcorder)
Video in (AVS)
Audio in right (AVS)
Audio in left (AVS)
AUDIO IN1 C - centre audio input (analogue)
AUDIO LINK - surround audio outputs (analogue)
HDMI1 - HDMI (DVI) input 1
USB connection
(USB stick/card reader)
ANT SAT (1
Satellite antenna
(Sat tuner 1)
AUDIO IN2 - audio input (analogue)
Common Interface 2
(CI-Slot 2)
Factory settings:
AV1: DVD player
AV2: DVD recorder
You can change this during the
initial installation (page 11) or in
the connection wizard (page 7).
Before you connect other devices
or make any changes, please start
the connection wizard (page 7)
and the sound components wizard
(page 41), and then follow the
instructions that are displayed on
the TV set. I N D I V I D U A L
DR+
Button +:
Station up
in the menu: to the right
On/Off button:
Switch on from the standby mode
Switch off to the standby mode
Button – :
Station down
in the menu: to the left 
Display:
= Standby
= Operation
= Operation without on-screen display
(Radio, EPG data capture or timer recording)
Button R:
Radio on/off (1 (back to TV mode)
Switch on the radio from the standby mode
in the menu: down 
Button M:
Call the menu
in the menu: up/down 
DR+ = Digital Recorder inactive
(no recording, no playback)
DR+ = Digital Recorder active (offset TV viewing
or archive playback)
DR+ = Digital Recorder active
(archive recording)
Display DR+:
The mains switch is located on the bottom
of the set in the middle