Lenoxx Electronics CD-10 - Manual (Page 9)

IB-CD10(SL)-WM-E-052605
PLAYING CD TRACKS IN PROGRAMMED ORDER OR
IN RANDOM ORDER
To change the current program
Just create a new program following the programming procedure.
To cancel Programmed Play
Press the STOP button twice.
8
You can make a program of up to 20 tracks in the order you want them to be played.
NOTE:
1. Programming can only be done while in STOP mode.
2. The programmed memory will be lost if the STOP button is pressed twice or the power
is shut off, or the CD door is opened.
1. Turn on the CD player by rotating the VOLUME/POWER
OFF switch downward past click. Make sure the CD is
stopped.
2. Press the REPEAT/PROGRAM button. The letters “ ”
and the PLAY/PROG. lamp will flash.
3. Press or to select the track you want to program in
the order you want.
4. Press the REPEAT/PROGRAM button to confirm. The
letters “ ” and the PLAY/PROG. lamp will flash.
5. Repeat above steps 3 and 4. You can program up to 20 tracks,
then the display will show the track numbers you programmed.
6. Press PLAY/PAUSE button to start programmed play. The
PLAY/PROG. lamp will flash.
REPEAT/PROGRAM button
PLAY/PAUSE button
SKIP/SEARCH buttons
VOLUME/OFF
sw itch
STOP button
POWER
PLAY/PROG.
REPEAT
POWER
PLAY/PROG.
REPEAT
POWER
PLAY/PROG.
REPEAT
RANDOM button
1.Programmed play
2.Random play
To play the songs in random order
Press the RANDOM button in STOP mode or during playing, the set will play all of the
songs in random order. The floating symbol “
”and the current
track number will show in turn in the display.
To resume normal play
Press the RANDOM button again, the player will start playing normally.
IB-CD10(SL)-WM-E-050705.pmd 5/26/2005, 9:23 AM 9