Lenoxx Electronics CD-10 - Manual (Page 5)

IB-CD10(SL)-WM-E-052605
You can use the AC power or batteries as a power source.
4
To a wall outlet
• Replace the batteries
when the P OWER lamp
dims or when the player
stops operating. Replace
all the batteries with new
ones. Remember to
check the Battery Safety
Instructions on Page 3.
1. Connecting the AC power
Insert one end of the supplied AC power cord into
the socket located at the rear of the set, and the
other end into the 120V, 60Hz standard household
outlet.
2. Using the player on batteries
Insert 6 size “C” batteries (not supplied) into the
battery compartment as shown, observe + and
polarities.
BATTERY DOOR
(on the back of the set)
CHOOSING THE POWER SOURCES
NOTE: One blade of plug
and outlet is wider.
TIP
• If the plug of the AC power
cord does not match your
outlet, do not for ce it.
Reverse it and try again.
The plug is polarized and
only fits one way into the
wall outlet and socket on
the set’s rear.
To use the player on batteries, disconnect the AC
power cord from both the wall outlet and the back of
the player.
Install batteries as illustrated
IB-CD10(SL)-WM-E-050705.pmd 5/26/2005, 9:23 AM 5