Linksys PAP2T - Manual (Page 13)

9 Chapter 4: Using the Phone Adapter’s Interactive Voice Response Menu
Using the Interactive Voice Response Menu
Internet Phone Adapter with 2 Ports for Voice-over-IP
Enable/Disable DHCP 101 Enter 1 to enable
Enter 0 to disable Enable or disable the Phone Adapter’s
DHCP feature. If your network router
assigns IP addresses, enter 1,
otherwise, enter 0.
Check IP Address 110 — Use this command to check the
current IP address of the Phone
Adapter.
Set Static IP Address 111 Enter the IP address
using the numbers on
your telephone
keypad. Use the
* (star) key to enter a
decimal point. To set a static IP address, the DHCP
feature must be disabled. If the DHCP
feature is enabled, you will hear,
“Invalid Option,” if you try to set a
static IP address.
Check Network Mask
(or Subnet Mask) 120 — Use this command to check the
current network mask of the Phone
Adapter.
Set Network Mask (or
Subnet Mask) 121 Enter the network
mask using numbers
on your telephone
keypad. Use the
* (star) key to enter a
decimal point. To set the network mask, the DHCP
feature must be disabled. If the DHCP
feature is enabled, you will hear,
“Invalid Option,” if you try to set the
network mask.
Check Static Gateway
IP Address 130 — Use this command to check the
current gateway IP address of the
Phone Adapter.
Set Static Gateway IP
Address 131 Enter the IP address
using numbers on
your telephone
keypad. Use the
* (star) key to enter a
decimal point. To set a static gateway IP address, the
DHCP feature must be disabled. If the
DHCP feature is enabled, you will hear,
“Invalid Option,” if you try to set a
static gateway IP address.
Interactive Voice Response Menu
Action Command
(press these
keys on the
telephone) Choices Description