La Crosse Technology WS-8056U - Manual (Page 6)

6
II) PROGRAM MODE
To enter the program mode hold down the “SET” button for 2 seconds, until
“-5EST” flashes in the date LCD. The program mode is laid out in a manner that
allows you to program each function separately, or you can follow the instructions
entirely to program the temperature alarm. Complete programming is usually done
for the initial set-up, and will require you to skip step 1 of programming sections III
through VIII. Press the “SNOOZE” button at any time to exit the program mode, or
wait approximately 15 seconds for the temperature alarm to automatically return to
normal operation.
A) FUNCTION BUTTONS
There are 3 function buttons located on the front
of the temperature alarm and one on the top. The
function buttons are labeled: “SET”, “+”,
“ALARM”, and “SNOOZE” (the top bar).
B) TIME ZONE SETTING
1) Hold down the “SET” button for 2 seconds,
the default setting “-5EST” will flash in the date LCD.
2) Press and release the “+” button to select the appropriate time zone. There
are 13 time zones to choose from:
3) Press and release the “SET” button to confirm the time zone setting, and to
advance to DST (Daylight saving time) setting.
-4ATL Atlantic Time
-5EST Eastern Time (default setting)
-6CST Central Time
-7MST Mountain Time
-8PST Pacific Time
-9ALA Alaskan Time
-10HAW Hawaiian Time
-11, -12 Next two time zones West of HAW
GMT Greenwich Mean Time
-1, -2, -3GMT Three time zones West of GMT