LG 32FZ4D-UA - Manual (Page 49)

P A G E 4 9
Programming the Remote
Test your remote control.
To find out whether your remote control can
operate the component without programming,
turn on the component such as a VCR and press
the corresponding mode button (VCR) on the
remote control, while pointing at the compo-
nent. Test the POWER and CH +/- buttons to see
if the component responds properly. If not, the
remote requires programming to operate the
device.
Turn on the component to be programmed, then
press the corresponding mode button on the
remote control.
Press the POWER and MUTE buttons simultane-
ously, the remote control is ready to be pro-
grammed for the code.
There are two ways to find the right code for the
component.
A. If you press the CH +/- buttons repeatedly,
the codes will change one at-a-time. Press the
POWER button after each code change. If the
right code is found, the device will turn off.
B. Enter a code number using the number but-
tons on the remote. Programming code num-
bers for the corresponding component can be
found on the following pages.
Again, if the code is correct, the device will
turn off.
Press the EXIT button to store the code.
Test the remote control functions to see if the
component responds properly. If not, repeat
from step 2.
1
1 2 3
4 5 6
7 8 9
0
TV
MODE INDEX POWER
TV INPUT COMP1
FRONT
VCR CABLE DVD SAT
MUTE
SURROUND FREEZE SAP RATIO
INFO
RECORD STOP PAUSE
REW
PLAY
FF
MENU EXIT
TIMER CC
SIGNAL
VOL CH
FAV
EZ SOUND EZ PIC
HDMI COMP2
TV/VIDEO
SKIP
DASH(-) FLASHBK
2
3
4
5
2
3
4
5
6
4
The remote control for your HD receiver is a multi-
brand or universal remote control. It can be pro-
grammed to operate most remote-controllable
devices of other manufacturers.
Note that the remote control may not control all
models of other brands.
3/4