Lumiscope 1095 - Manual (Page 8)

Subsequent Measurement
When a second measurement needs to be made,
the time between two measurements should be at
least teb minutes.
Automatic Power OFF Function
If unit is left on after measurement, an
“Automatic Power-OFF Function” turns the
power off after approximately one minute. To
continue with another measurement press the
“ON/OFF/START” switch to turn the unit on.
Memory Recall Function
• Stores the last sixty readings in sequential
order (1-60). When sixty-first reading is taken,
the oldest recorded measurement (1) is delet-
ed.
• Press MEMORY to recall the last measured
blood pressure reading.
• Each time you press the MEMORY button it will
recall the next previous set of readings.
• The memory function does not work during auto-
matic inflation or while blood pressure measure-
ments are being made.
• All readings stored in memory will be displayed with
its sequence number.
7
NOTE: All memories will be deleted when batteries are replaced.