Lathem LTR4-512 - Manual (Page 9)

LTRx-512 User’s Guide
ENT.DATE: 04-03-2003
TODAY IS THURSDAY
ENTER TIME: 21:00
PRESS [#] IF CORRECT
Press the [#] key at the top (‘00’ seconds) of the new minute to accept. If the time or date is not
correct, press [*] to cancel and try again.
The display will now show the time and date you just entered. You can toggle between the
12-hour and 24-hour display using “Quick Check” command [3]
Make sure you enter the correct date and day, because the schedules you setup depend on
these choices
[2]=Select Clock Control
This function requires the administrator password
Use this function to choose the make/model of the clocks that your Master will synchronize
(Note: The LTR4-512 can only synchronize one type of secondary system)
Enter your administrator password, then start this function by pressing [#][2][#]
ENABLE CLOCK CIRCUIT
SELECT CLK1 CODE: NN
[#] FOR CODE LIST
Enter the 2-digit code for CLOCK1, then press [#]. If you entered a code other than ‘00’, and
you have a LTR8-512 or LTR8-512M, you will see
ENABLE CLOCK CIRCUIT
SELECT CLK2 CODE: NN
[#] FOR CODE LIST
Enter the code for CLOCK2, or [0][0] if you will not use a CLOCK2, then press [#]
PRESS
[#] IF CORRECT
Enter [#] to confirm or [*] to cancel and try again
9