Leviton Internet Gateway - Manual (Page 2)

Environmental Specifications
Dimensions:
2.5˝H x 6.5W˝ x 3.27˝D
Power: 12VDC@1000mA
Emissions: FCC ClassB
Operating Temperature: 0°C to 50°C (32°F to 122°F)
Storage Temperature: -40°C to 70°C (-40°F to 158°F)
Operating Humidity: 20% to 95% relative humidity, non-condensing
Storage Humidity: 20% to 95% relative humidity, non-condensing
Cable Specifications
Ethernet Type
Cable Requirements Maximum Length
10BASE-T Category 3 or better, UTP or STP 328 ft (100M)
100BASE-TX Category 5 or better, UTP or STP 328 ft (100M)
1000BASE-T Category 5e or better, UTP or STP 328 ft (100M)
NOTE: Do not use telephone cables. Telephone cables do not support Ethernet or Fast Ethernet.
APPENDIX
A: About Static and Dynamic IP Address
A static IP address is an IP address that is assigned to a computer by an Internet service provider to be
its permanent address on the Internet. It is normally used in the computer networks, where computers
are connected all the times. As the Internet gets more crowded, there are not enough IP numbers to go
around. For this reason, more and more ISPs are offering dynamic IP address instead. Check with your
ISP if they provide you a Static IP address. A dynamic IP address is a temperately IP address assigned by
a DHCP (Dynamic Host Configuration Protocol) server from a pool of IP addresses. A dynamic IP address
may change every time when you log in the network.
INSTALLATION
1: INTRODUCTION
As the interface between WAN and LAN, the Gateway provides a secure solution for Internet access over
a shared netowrk in a home or small office environment. With the built-in NAT technology, the Gateway
delivers firewall protection, preventing network intruders and hackers. Compliant with IEEE 802.3, IEEE
802.3u standards and designed as a DHCP server, the Gateway offers high-speed network connectivity ,
providing up to 253 users access through one Internet connection and the ability to assign IP addresses
to the devices on your LAN.
Designed with a management utility, the Gateway can block specific interior users’ Internet access and
offer the network administrator remote access capabilities.
Features
· Supports PPPoE, PPTP Client, and Dynamic DNS
· Connects to a cable/DSL modem or to an Ethernet backbone
· Includes with a 4-port 10/100 Mbps Switch
· Creates a firewall to protect your computers from outside intruders
· Acts as either a DHCP server on the LAN or a DHCP client on the WAN
· Configurable through any networked PC’s web browser
· Users will be able to access the internal IP servers via the Internet, using the virtual server feature.
· Administrators can block specific interior users’ Internet access
Package Contents
· One 10/100Mbps 4-Port Internet Gateway
· One AC/DC Power Adapter
· QuickStart Guide
System Requirement
· One RJ-45 Cable/DSL network connection
· One computer with installed 10/100 Mbps Ethernet Adapter
· UTP network cable with RJ-45 connector
· Windows 95/98/2000, WindowsME, or Windows NT for the Web-based Configuration
· Microsoft Internet Explorer 4.0 (or above version) or Netscape Navigator 4.0 (or above version)
2: HARDWARE
Front Panel (Figure 1)
The front panel of the Gateway includes Power and Diagnostic LEDs, Link/Activity, FDX/Colission and
10/100 LED indicators. The front panel also features one WAN port, four RJ-45 Ports and one Uplink port
designed to easily cascade additional devices.
2 19
1 1 2 3 4 2 3 4 Uplink WAN WAN
10/100 Mbps 4-port Internet Gateway
Power
Diag Link/Act
Fdx/Col
100/10
1