Chapter 2: configuration, Overview, Configuration – Linksys WAPPOE12 User Manual
Page 7
Chapter 2
Configuration
4
12 Volt Power Over Ethernet Adapter Kit
Chapter 2:
Configuration
Overview
This chapter gives instructions on how to connect the
Power Over Ethernet Kit. Once connected, the Kit will
transmit data and power over the Ethernet network cable
to your remotely located network device.
The diagram shows an example of how the Kit can be
connected to a wired switch and a wireless access point.
Power
Ethernet
Wireless
Ether
net
Ether
net
Power
Up to 328
To connect the Kit to a device with a conventional power
port, proceed to the section, “Power on a Device that Uses
a Standard Power Adapter.” To connect the Injector to a
device that supports inline power, proceed to the section,
“Power on a Device that Uses Inline Power.”
Power on a Device that Uses a Standard
Power Adapter
Use the Injector and Splitter to power up a device that
uses a standard power adapter. Follow these instructions:
Connect the Injector’s built-in Ethernet network cable
1.
to your router, switch, or other network device.
Connect the Kit’s included Ethernet network cable to
2.
the Injector’s Power & Data OUT port.
NOTE:
If this cable is not long enough, then you
can use your own Ethernet network cable.
Then connect the other end to the Splitter’s Power &
3.
Data IN port.
Connect the Splitter’s built-in Ethernet network cable
4.
to the Ethernet port of your remotely located access
point or other network device.
Connect the Splitter’s Power cord to the Power port of
5.
your remotely located access point or other network
device.
NOTE:
If the plug of the Splitter’s Power cord
does not fit into your network device, then
use the included barrel jack adapter. Plug the
Splitter’s Power cord into the jack end, and plug
the other end of the barrel jack adapter into the
Power port of your network device.
Connect the Kit’s power adapter to the Injector, and
6.
plug the other end into an electrical outlet or surge
protector.
Congratulations! The installation of the 12 Volt Power
Over Ethernet Kit is complete.