Replacing the cover and connecting the cables, Replacing, Cover – Lenovo ThinkVision E50 User Manual
Page 39: Connecting, Cables
Note:
If
your
system
board
has
only
two
pins
for
clearing
CMOS,
just
remove
the
jumper
from
the
two
pins.
6.
Replace
the
computer
cover
and
connect
the
power
cord.
See
Replacing
the
cover
and
connecting
the
cables
After
working
with
options,
you
need
to
install
any
removed
parts,
close
the
computer
cover,
and
reconnect
cables,
including
telephone
lines
and
power
cords.
Also,
depending
on
the
option
that
is
installed,
you
might
need
to
confirm
the
updated
information
in
the
Setup
Utility
program.
To
replace
the
computer
cover
and
connect
cables
to
your
computer:
1.
Ensure
that
all
components
have
been
reassembled
correctly
and
that
no
tools
or
loose
screws
are
left
inside
your
computer.
2.
Reposition
any
cables
that
might
impede
the
replacement
of
the
computer
cover.
3.
Align
the
drive
bay
assembly
with
the
two
slots
and
rails
on
the
sides
of
the
chassis,
reconnect
the
drive
cables
on
the
system
board,
and
then
slide
the
drive
bay
assembly
towards
the
rear
of
the
chassis
until
it
snaps
into
position.
4.
Reinstall
the
two
screws
that
secure
the
drive
bay
assembly.
5.
Reinstall
the
front
bezel
if
it
was
removed.
6.
Position
the
computer
cover
on
the
chassis
so
that
the
rail
guides
on
the
sides
of
the
cover
engage
the
rails
and
push
the
cover
to
the
closed
position.
Install
the
two
screws
that
secure
the
computer
cover.
7.
Install
any
locking
devices
such
as
a
padlock
as
necessary.
8.
If
your
computer
is
being
placed
in
the
vertical
position,
attach
the
floor
stand.
9.
Reconnect
the
external
cables
and
power
cords
to
the
computer.
See
10.
To
update
the
configuration,
see
Chapter
1.
Installing
options
23