LevelOne NetCon WBR-3408 - Manual (Page 36)

PC Configuration
Wireless Station Configuration
This section applies to all Wireless stations wishing to use the Wireless Broadband
router's Access Point, regardless of the operating system which is used on the client.
To use the Wireless Access Point in the Wireless Broadband router, each Wireless
Station must have compatible settings, as follows:
Mode The mode must be set to Infrastructure.
SSID (ESSID) This must match the value used on the Wireless Broadband
router. The default value is default
Note! The SSID is case sensitive.
Wireless
Security By default, Wireless security on the Wireless Broadband router is
disabled.
• If Wireless security remains disabled on the Wireless Broad-
band router, all stations must have wireless security disabled.
• If Wireless security is enabled on the Wireless Broadband
router, each station must use the same settings as the Wire-
less Broadband router.
Note:
By default, the Wireless Broadband router will allow both 802.11b and 802.11g con-
nections.
33