LevelOne FBR-1700TX - Manual (Page 21)

Installation
17
2. Connect LAN Cable
Use standard LAN cables to connect PCs to t he Switching Hub ports on the LevelOne
Broadband Router. Both 10BaseT and 100BaseT connections can be used simultaneously.
If required, connect any port to a normal port on another Hub, using a standard LAN cable.
Any LAN port on the LevelOne Broadband Router will automatically function as an "Up-
link" port when required.
3. Connect WAN Cable
If you have a DSL modem or Cable modem, connect it to the WAN port on the LevelOne
Broadband Router. Use the cable supplied with your modem. If no cable was supplied, use
a standard LAN cable.
4. Power Up
Connect the supplied power adapter and power up.
Use only the power adapter provided.
5. Check the LEDs
• The Status LED should flash, then turn Off. If it stays on, there is a hardware error.
• The Power LED should be ON.
• One (1) of the LAN LEDs (10 or 100) should be ON.
• The WAN LED should be ON.
For more information, refer to LEDs - FBR-1400TX in Chapter 1.