Manual hand crank – Linak LA36 User Manual
Page 11

11
The cover over the Allen key socket must be unscrewed before the Allen
key can be inserted and the hand crank operated.
Hand Crank Torque: 6 - 8 Nm ( 2600 N – 6800 N load )
Piston rod movement per turn, app.:
Application hints
The actuator is weatherproof for use in outdoor applications. The actuator can be
washed down with a high-pressure washer, but it should not be used under water.
Optionally the actuator is overload protected with a slip clutch. The clutch will slip
when the load exceeds approx. 1.2 - 1.4 times the actuator’s rating.
The duty cycle at max. load is 20% on time. This means if the actuator runs con-
tinuously for 20 seconds it must remain off for 80 seconds before operating again.
NB. At 10,000 N only 5%
The manual hand crank can be used in the case of power failure.
Note: if the actuator is operated as a hand crank, it must be operated by
hand, otherwise there is a risk of overloading the actuator and hereby damage
the actuator.
6 mm Allen key
Manual hand crank
8 mm
12 mm
20 mm
Gear A
-
11 mm
18 mm
Gear B
-
6 mm
10 mm
Gear C
3 mm
4 mm
7 mm
Gear F
-
-
27 mm
• The power supply has to be disconnected during manual operation
• If the actuator is operated as a Hand crank, it must be operated by hand or
carefully by machine, otherwise there is a potential risk of overloading and
hereby damaging the actuator. LA36 with CS or MODBUS options only by hand
• With stainless steel screws: 5 mm Allen Key