Lenovo NETWORK CARD - WIRELESS ADAPTER MW600-B-LO - Manual (Page 6)

3
MW600-B-LO Wireless 802. 11b/g wireless PCI-E Adapter Card
3) For all products market in US, OEM has to limit the operation channels in CH1
to CH11 for 2.4G band by supplied firmware programming tool. OEM shall not
supply any tool or info to the end-user regarding to Regulatory Domain change.
As long as 3 conditions above are met, further transmitter test will not be required.
However, the OEM integrator is still responsible for testing their end-product for
any additional compliance requirements required with this module installed (for
example, digital device emissions, PC peripheral requirements, etc.).
Important note: In the event that these conditions can not be met (for example
certain laptop configurations or co-location with another transmitter), then the FCC
authorization is no longer considered valid and the FCC ID can not be used on the
final product. In these circumstances, the OEM integrator will be responsible for
re-evaluating the end product (including the transmitter) and obtaining a separate
FCC authorization.
Manual Information To the End User
The OEM integrator has to be aware not to provide information to the
end user regarding how to install or remove this RF module in the user’s
manual of the end product which integrates this module.
The end user manual shall include all required regulatory information/warning as
show in this manual.
Important information
Please read the information below before using the MW600-B-LO 11b/g wireless
PCI- Express card on your system.
What’s new
The latest generation PCI (Peripheral Component Interconnect) bus architecture
called PCI Express, uses a 2.5- GHz serial Input/Output structure for higher
bandwidth and better scalability than its previous architectures. .
Features
• PCI Express PCIe interface.
• X1-lane 2.5Gbps PCI Express host interface, Low profile
• IEEE 802.11g compliant.
31036026_MW600_UG_EN.indd 3 2008.11.7 10:59:27 AM