Technical specifi cations – Lyngdorf Audio RoomPerfect RP-1 User Manual
Page 35

3 5
Technical Specifi cations
Audio
Parameter
Value
Note
Balanced input connectors
3 pin XLR, gold-plated.
Case=Gnd, Pin1=Gnd,
Pin2=Hot(+), Pin3=Cold(-)
Balanced input impedance
10KOhm
AC-coupled.
Unbalanced input connectors
RCA (phono) jack, gold-plated.
Case=Gnd, Tip=Hot(+)
Unbalanced input impedance
10KOhm
AC-coupled
Input sensitivity
4.4V (2.2V with high sens.)
DAC Out impedance
50Ohm
Unbalanced output
Unity
0dB according to input level
Balanced output
Unity
0dB according to input level
Frequency Response 20 - 20KHz +/-0.1dB
RoomPerfect Highpass Filter
-3dB at 18Hz
THD+N A-wgt
Analog to Analog
-103dB
Neutral voicing - ref 4.4V
S/N Ratio
Analog to Analog
113dB
Neutral voicing - ref 4.4V
Dynamic Range
Analog to Analog
113dB
Neutral voicing - ref 4.4V
Channel Separation
114dB
AC Sweep from 125 - 16KHz
All audio measurements, except frequency response, are measured with a 20KHz low-pass fi lter in ac-
cordance with AES-17.
Protection
Parameter
Value
Value
Grounding
Mains earth, chassis and audio
ground are connected internally.
Over temperature
Mains-transformer.
Auto resetting thermal fuse in
mains transformer.
Mains
Parameter
Value
Note
Mains input connector
IEC 320 cold type
Mains lead supplied.
Mains voltage range
100-240V AC, 50–60Hz
Power consumption
4 W
STANDBY mode. 230V AC.
Power consumption
23 W
OPERATE mode. 230V AC.
Mechanical
Parameter
Value
Note
Width
450mm (17.72”)
Depth
355mm (13.98”)
Height
100mm (3.94”)
Including feet.
Net weight
6.6 Kg (14.6 lb.)
Shipping weight
9.9 Kg (21.8 lb.)
2 shipping boxes