Cloning procedure troubleshooting, Master and other 20lh1dc1, Appendix – LG 20LH1DC1 User Manual
Page 69: Cloning did not work, Clone time disappeared, New setup not present, Clone not working, Clone scans channels more than once
APPENDIX
69
CLONING PROCEDURE TROUBLESHOOTING
• After cloning operations are complete, just unplug the LT2002 from the 20LH1DC1.
• If the 20LH1DC1 does not display a picture on the TV (blank screen) after a few seconds, just change channels.
Master and Other 20LH1DC1
8
Wait until procedure complete message is displayed.
Procedure interrupted.
8
Cloning is only possible with identical model TVs.
Different TV models.
8
Reread 52 - 53 - 54 pages to be sure all tasks were performed.
Step(s) omitted or not
performed.
8
Redo cloning and be sure learning/teaching time is about 1 min. and 5 to15 seconds (75 seconds).
Insufficient cloning time.
8
Reset Clone Programmer.
Cloning erratic.
Cloning did not work.
8
Batteries must remain installed to retain time settings.
Batteries were removed.
Clone time disappeared.
8
Disconnect newly cloned unit from power for 5 seconds.
20LH1DC1 not reset.
New Setup not present
8
Try a different LT2002 Clone programmer.
8
Reset Clone Programmer.
Clone programmer problem.
Clone not working
8
Retry cloning again.
Clone should only scan
channels once.
Clone Scans Channels more than once.