Hold function, Flash function, Last number redialing pause function – Lenoxx Electronics PH-5562 User Manual
Page 7
IB-PH5562-WM-E-010807
STORING PHONE NUMBERS INTO MEMORY
1. Press the STORE button.
(short for programming) appears in the display..
2. Dial the phone number you want to store. You can store up to 22 digits (including a
TONE (
TONE
) and a PAUSE (REDIAL/PAUSE), each of which is counted as one digit).
NOTE: When the batteries are dead or removed for more than five minutes, the stored
numbers may be erased.
3. For 3 one-touch dialing:
For 10 two-touch dialing:
Press one of the 3 one-touch
speed dial buttons (M1 to M3).
4. The stored number and the location will be shown in the display.
Press AUTO button, and then press one of the
dialing keys (0 to 9) to store a phone number in.
5. Repeat steps 1 to 4 to store numbers into other memory locations.
HOLD FUNCTION
You can temporarily hold the line by pressing the HOLD button during conversation, “HOLD”
will flash in the display, and you can replace the handset on the base without disconnecting
the call. Picking up the handset or pressing the SPEAKERPHONE button on this phone or
any phone on the same line will stop the hold function.
FLASH FUNCTION
Useful for call waiting or getting a new dial tone.
2. For 3 one-touch dialing:
For 10 two-touch dialing:
Press one of the 3 one-touch
speed dial buttons (M1 to M3).
Press the AUTO button, and then press one of
the dialing keys (0 to 9).
3. The phone will dial the numbers you stored into that memory.
MEMORY DIALING
1. Pick up the handset or press the SPEAKERPHONE button.
1. Pick up the HANDSET or press the SPEAKERPHONE button.
2. Press the REDIAL/PAUSE button. The last dialed number appears in the display and is
automatically dialed.
LAST NUMBER REDIALING
PAUSE FUNCTION
Example: In an office where you need to dial a 9 first to get an outside line.
Dial the number 9 and press REDIAL/PAUSE button, and then dial the phone number. You
will see a “ ” displayed for pause. You may also store this into memory..
6
IB-PH5562-WM-E-010807.pmd
1/23/2007, 5:08 PM
7