Lowrance electronic EP-60R - Manual (Page 32)

32
data from a single engine or from all engines on the vessel. (If you select
F
UEL
R
ANGE
or if your unit is configured for one engine, you will be taken
back to the Position menu.)
5. Select the desired engine or, to display data from all engines,
highlight Vessel and press
ENTER
. You will be taken back to the
Position menu. To display data in another data box, repeat Steps 3-5.
6. Press
EXIT
twice to return to the main display.
To customize Fuel Manager page:
1. After the Fuel Manager page has been added to the page screen
rotation, use the
ENTER
and
EXIT
keys to display it on the main screen.
2. Press
MENU
, use the
UP
and
DOWN
keys to select
C
USTOMIZE
and press
ENTER
. The Position menu will appear with three options: Top Data,
Center Data and Bottom Data.
3. Highlight the desired data position and press
ENTER
.
4. Select
F
UEL
F
LOW
,
F
UEL
R
ANGE
,
F
UEL
U
SED
,
T
RIP
F
UEL
U
SED
or
S
EASONAL
F
UEL
U
SED
and press
ENTER
. A menu will appear, allowing you to display
data from a single engine or from all engines on the vessel. (If you select
F
UEL
R
ANGE
or if your unit is configured for one engine, you will be taken
back to the Position menu.)
5. Select the desired engine or, to display data from all engines,
highlight Vessel and press
ENTER
. You will be taken back to the
Position menu. To display data in another data box, repeat Steps 3-5.
6. Press
EXIT
twice to return to the main display.
Reset Values
By accessing Reset Values from the Fuel Flow menu, you will be able to
reset configuration and calibration settings for a particular fuel flow.
NOTE:
After using the Reset Values command, you will have to re-enter
your engine-tank configuration. It, however, will not affect the
configuration or calibration of other devices on the network.
To reset values:
1. Press
MENU
, use the
UP
and
DOWN
keys to select
S
YSTEM
S
ETUP
and
press
ENTER
.
2. Highlight
B
US
D
EVICES
and press
ENTER
. Select the fuel flow you want
to reset and press
ENTER
.
3. Choose
R
ESET
V
ALUES
from the fuel flow menu and press
ENTER
. The
following message will appear: Press Enter to Reset Device Values.
4. Press
ENTER
and you will be taken back to the Bus Devices list.