La Crosse Technology WWVB WS-7394U - Manual (Page 5)

5
DETAILED SET-UP GUIDE
I. Battery Installation
Batteries will fit tightly. To avoid start-up problems, make sure that the
batteries do not spring free. Also be sure to insert alkaline batteries into the
remote temperature sensor first, then the indoor weather station. Initial set
up should be done with the remote temperature sensor and indoor weather
station in the same room. The units should be permanently mounted only
after the signal reception has been verified.
A. Remote Temperature and Humidity Sensor
1. Remove the mounting bracket. The bracket
snaps on and off easily.
2. Remove the battery cover, by sliding the cover
down.
3. Observing the correct polarity install 2 AA
batteries. The batteries will fit tightly (to avoid
start-up problems make sure they do not spring
free).
4. 4. Replace the battery cover by sliding
upwards. Be sure battery cover is on securely.
B. Indoor Weather Station
1. Remove the battery
cover (the cover has
white writing on it).
2. Observe the correct
polarity, and install
two Alkaline AA
batteries.
3. Do not press any
buttons for at least
ten minutes. If a
button is pressed
before the indoor
weather station has
received information
from the TX4U
sensor, no data will
be received from that
sensor until reset.
4. Replace the battery
cover.
Battery
Cover