Viii – La Crosse Technology WT-941 User Manual
Page 2
Battery clip
Battery
compartment
to 100 feet, do not submerge in water for extended periods of time.
1.
ADJUSTING THE STRAP
The rubber strap is adjustable to fit most all wrist sizes. It is also
replaceable with a properly sized band available at a local watch or
department store. The strap is held in place by a pin on each side.
VIII.
REPLACING THE BATTERY
The battery can either be replaced by a qualified jeweler or watch repair shop,
or by the user.
Any damage resulting from this procedure
is not covered under warranty.
1.
Remove the four screws located
on the back and remove the cover.
Be sure the watch movement and
gasket do not come out of
the case.
2.
Remove the old battery
by gently prying up the
battery clip.
3.
Insert a new battery of the type “CR1620” 3 Volt Lithium Cell battery
4.
Please dispose of the old battery properly.
TROUBLESHOOTING
Problem:
No WWVB signal (indicated by the absence of the WWVB tower icon).
Solution:
1) Check the selected Time Zone. If it is set between GMT+1 and GMT
+12, the WWVB signal will not be received. Change the Time Zone.
2) Move watch 10 feet (3 meters) away from any interfering sources, i.e.
electrical appliances (refrigerators, TV’s, computers), metal surfaces or
objects.
3) To help with overnight reception, place watch in a window with the
band inline with the general direction of Ft. Collins, Colorado.
4) There are a few places the signal is very weak (Los Angeles area, Some
parts of Florida and New York City). Since the watch has a much smaller
receiver than our other clocks, it is possible no reception can be made.
Please inform La Crosse Technology in this case.
Problem:
The watch displays “-:--” and no date
Solution:
1) The watch entered the power off mode and was reactivated. No signal
has been located, and no time is set. Once the watch receives the time
signal successfully (usually at night), it will display the correct time and
date (Eastern Time zone is the default).
Problem:
The hour or minute is incorrect, even though the tower icon is on
(indicating a successful reception of the WWVB time signal the previous
night) and it is set to the proper time zone.
Solution:
1) Electrical interference caused the time signal to be improperly received.
Be sure the watch is at least six feet from any source of electrical activity
(television, computer). Overnight it should correct itself.
2) You may need to perform a reset; follow the directions outlined in
section IV.
Note: For all questions not answered contact La Crosse Technology (contact
information is below).
WARRANTY INFORMATION
La Crosse Technology provides a 1-year warranty on this watch. Contact La Crosse Technology
immediately upon discovery of any defects covered by this warranty. Before sending the watch in
for repairs, contact La Crosse Technology. The watch will be repaired or replaced with the same
or similar model. This warranty does not cover any defects resulting from improper use,
unauthorized repairs, faulty batteries, or the watch’s inability to receive a signal due to any source
of interference.
LA CROSSE TECHNOLOGY WILL NOT ASSUME LIABILITY FOR INCIDENTAL,
CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH
THE OPERATION OR MALFUNCTION OF THIS WATCH. THIS PRODUCT IS NOT TO BE
USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. THIS PRODUCT IS
NOT A TOY. KEEP OUT OF CHILDRENS’ REACH.
This warranty gives you specific legal rights. You may also have other rights specific to your
State. Some States do no allow the exclusion of consequential or incidental damages therefore the
above exclusion of limitation may not apply to you.
For warranty work, technical support, or information contact:
La Crosse Technology
2809 Losey Blvd. S.
La Crosse, WI 54601
Phone: 608.782.1610
Fax: 608.796.1020
e-mail:
(warranty work)
(information on other products)
web:
www.lacrossetechnology.com
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS: THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE,
AND THIS DEVICE MUST ACCEPT INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.