Lowrance electronic Lowrance iFINDER Pro - Manual (Page 22)

14
Com-1 wiring to receive NMEA position information
from some other GPS receiver.
MMC or SD Memory Card Installation
Your iFINDER uses a MultiMedia Card to store information, such as
custom maps, waypoints and other GPS data. The unit can also use Se-
cure Digital Cards (SD cards) to store information.
NOTE:
Throughout this manual, we will use the term MMC, but just re-
member that your unit can use an MMC or SD Card to store data.
Both of these solid-state flash memory devices are about the size of a
postage stamp. An SD card is slightly thicker than an MMC. As this
manual went to press, MMCs were available in storage capacities of 8
MB, 16 MB, 32 MB, 64 MB and 128 MB. SD cards were available in
capacities of 8 MB, 16 MB, 32 MB, 64 MB, 128 MB, 256 MB and up. We
have successfully tested SD cards up to 512 MB.
Additional MMC cards are available from LEI Extras; see ordering in-
formation inside the back cover of this manual. MMCs and SD cards
are also available at many consumer electronics stores.
The MMC slot is located in the battery compartment, behind the bat-
teries on the right side of the unit. The battery compartment decal
points out the slot, which is also marked by small white letters on the
circuit board.
To remove an MMC
1. Remove battery compartment cover.
2. Remove batteries, if present.
3. Hold unit upright in left hand. Use a thumbnail or fingernail to grab
the groove along the bottom edge of the MMC.
4. Drag the MMC from the slot into the battery compartment.
5. Hold iFINDER face up and give it a shake to dump the MMC into
your hand or onto a work surface.
To add an MMC or SDC
1. Remove battery compartment cover.
2. Remove batteries, if present.
Ground
To Other
Device
Com-1
To unit
Yellow (Receive) NMEA Transmit
Shield (Ground)