Lenoxx Electronics CD-2036 - Manual (Page 9)

IB-CD2036(SY)-WM-E-010805
PLAYING CD TRACKS IN PROGRAMMED ORDER
To change the current program
Just create a new program following the programming procedure.
To cancel Programmed Play
Press the STOP button, then slide the FUNCTION switch to TAPE/OFF position.
8
You can make a program of up to 20 tracks in the order you want them to be played.
NOTE:
1. Programming can only be done while in STOP mode.
2. The programmed memory will be lost if the STOP button is pressed twice or the power
is shut off, or the CD door is opened.
1. Slide the FUNCTION switch to CD position.
Make sure the CD is stopped.
2. Press the PROGRAM button. The letters “ ”
and the PROG. lamp will flash.
3. Press or to select the track you want to
program in the order you want. The track
number you selected will be steadily on and the
PROG. lamp will flash.
4. Press the PROGRAM button to confirm. The letters
“ ” and the PROG. lamp will flash.
5. Repeat above steps 3 and 4. You can program up
to 20 tracks, then the display will show the tracks
number you programmed, and the PROG. lamp
will flash.
6. Press to start programmed play. The PROG.
lamp will be steadily on.
POWER
STOP
FM ST.
PROGRAM
SKIP/SEARCH
REPEAT
PROG.
PLAY/
PAUSE
PLAY
PAUSE
REPEAT
PROGRAM button
PLAY/PAUSE
button
REPEAT button
STOP button
SKIP/SEARCH buttons
POWER
FM ST. PLAY/
PAUSE
REPEAT
PROG.
POWER
FM ST. PLAY/
PAUSE
REPEAT
PROG.
POWER
FM ST. PLAY/
PAUSE
REPEAT
PROG.
IB-CD2036(SY)-WM-E-010805.PMD 2/23/2005, 2:38 PM 9