Linear PERS-3600B User Manual

Page 4

7. TRANSMITTER INSTALLATION OPTIONS

8. INSTALLING SINGLE TRANSMITTERS

5. TRANSFORMER INSTALLATION

6. APPLY POWER - SELECT DIALING METHOD

PLUG TRANSFORMER
INTO AN UN-SWITCHED
AC OUTLET

SECURE
TRANSFORMER
WITH SCREW

WHEN IT IS INSTALLED
WITH THE JUMPER SET
FOR INSTANT

IT WILL

FUNCTION

AS ACTIVITY

FOR DXS-31 STATIONARY TRANSMITTERS

WHEN IT IS INSTALLED
WITH THE JUMPER SET
FOR DELAY

IT WILL

FUNCTION

AS EMERGENCY

WHEN IT IS
INSTALLED
WITH THE
RIGHT BUTTON

IT WILL ONLY
ACTIVATE
USING BOTH
BUTTONS

FOR ALL TWO-BUTTON TRANSMITTERS

WHEN IT IS
INSTALLED
WITH THE
LEFT BUTTON

IT WILL
ACTIVATE
USING
EITHER
BUTTON

FOR MODEL DXS-32: CUT JUMPER (INSTANT TX) FOR USE

AS AN ACTIVITY TX. SEE DXS-32 INSTALLATION INSTRUCTIONS

ADDS ONE TRANSMITTER AT A TIME

PRESS CANCEL BUTTON
FOR 5 SECONDS
• CONSOLE ANNOUNCES
THAT IT IS READY TO
LEARN TRANSMITTERS

ACTIVATE TRANSMITTER
• CONSOLE ANNOUNCES
TRANSMITTER TYPE THEN
REVERTS TO STANDBY MODE

NOTE: IF THE CONSOLE'S MEMORY
IS FULL, THE CONSOLE WILL ANNOUNCE
"ERROR ZONES FULL"

REPEAT STEPS 1 & 2 FOR ADDITIONAL
TRANSMITTERS (UP TO 16 TOTAL)

NOTE: PRESS CANCEL BEFORE TRANSMITTING TO RETURN
TO STANDBY MODE WITHOUT ENTERING A TRANSMITTER
• THE CONSOLE WILL ANNOUNCE ITS STATUS

THE CONSOLE WILL RETURN TO STANDBY MODE AUTOMATICALLY
WHEN A TRANSMITTER IS LEARNED OR AFTER 30 SECONDS
HAS ELAPSED

DXS-62A

NOTE: WRITE DOWN EACH TRANSMITTER'S TYPE AND ZONE NUMBER
WHEN THE TRANSMITTER IS ADDED. THE CENTRAL STATION WILL NEED
TO KNOW THE TYPE AND REPORTING ZONE FOR EACH TRANSMITTER.

SLIDE POWER
SWITCH ON

IF REQUIRED, CHANGE THE DIALING METHOD BY PRESSING
AND HOLDING THE HOME & CANCEL BUTTONS FOR 3 SECONDS
WHILE SWITCHING THE POWER ON

• 7 BEEPS SOUND FOR PULSE DIALING
• 8 BEEPS SOUND FOR TONE DIALING

NOTE: THE DEFAULT DIALING METHOD IS TONE DIALING

OFF