Lanier LW 210 - Manual (Page 62)

PAPER/TONER
Notes on Paper
S
Do not set the following paper. Otherwise, a paper jam might occur.
•
Bent, folded, or creased paper
•
Torn paper
•
Perforated paper
•
Non-smooth paper
•
Slippery paper
•
Thin paper that has low stiffness
S
Do not make a copy on paper with any kind of coating, such as thermosen-
sitive paper, art paper, aluminum foil, and carbon paper. Otherwise, a fault
might occur.
S
If you make a copy on edged paper, the copy might be creased or a part of
the image might not be copied.
S
When you use roll paper, the roll must be black.
S
When film is delivered from the copier, it is softened due to the fusing heat.
Place the film on a flat surface until the remaining heat is removed from the
film.
S
If you make a copy on rough paper, the copy image might be blurred.
S
Keep paper away from humidity. Once you unpack the container of paper,
store the paper in a polyvinyl bag in the following locations:
•
Location free from direct sunlight
•
Location with the humidity of 70
% or less
•
Flat location
Toner
S
Store toner cartridges levelly in the following locations:
•
Location free from direct sunlight
•
Locations the toner could be
subjected to temperature of over
35 °C, 95 °F
R
WARNING: Do not incinerate toner or toner containers. Toner dust
might ignite when exposed to open flames.
Dispose of the used toner container according to local
regulations.
❐
Do not store toner where it will be exposed to heat.
❐
Do not eat or swallow toner, and keep it out of reach of
children.
54 MAINTAINING YOUR COPIER