Lenoxx Electronics PH-417 - Manual (Page 12)

IB-PH417-WM-E-022804
No dial tone.
1. Plug disconnected from jack.
2. Jack improperly wired.
Phone is dead.
1. Damaged cord.
2. Jack improperly wired.
3. Line out of order.
1. If your other telephones are “ROTARY” type
phones, your line may be conditioned to
accept PULSE dialing only.
Move TONE/PULSE switch to PULSE position.
2. Contact your phone company to have your
line changed to TONE and PULSE service.
Static noise on line or cannot hear
calling party or calling party
cannot hear you.
Replace the coil cord. Any phone store has
these cords in different lengths.
1. If problems with your telephone service occur later, try to determine if the trouble is
with the telephone or with the telephone company equipment. Unplug the telephone
and try it on another jack in a different room or in a neighborhood’s home to see if the
phone line is bad or the phone.
2. If disconnection of your equipment ends the problem, your telephone may be the
source of the trouble and it should be tested and repaired if necessary before it is
reconnected.
3. There are no user maintainable parts or adjustments on this set. Should your phone
require repair, contact us for instructions (except for cords which you can buy at
any phone store).
TROUBLE SHOOTING
RINGER switch in OFF position.
Slide the switch to ON position.
PROBLEM LIKELY CAUSES
Can receive, but cannot make
calls.
Can make calls, but phone does
not ring.
11
IB-PH417(MS)-WM-E-022804.p65 2/27/2004, 12:28 PM 12