Radius support for ip fax operation, Radius support for ip fax operation -10 – Lucent Technologies 6000 User Manual
Page 344
7-10
MAX 6000/3000 Network Configuration Guide
Configuring IP Fax
Configuring IP fax options
RADIUS support for IP fax operation
The following RADIUS attributes, which appear in Accounting Stop packets, provide
outgoing and incoming call values for IP fax calls:
eventTimeStamp
For an IP fax call, the time that the modem is reserved for an
outgoing call request. For any other type of call, this field
reports the actual connected time. This information is available
when the event type is callCleared(3).
eventInOctets
Total received bytes for the call. This information is available
when the event type is callCleared(3).
eventOutOctets
Total transmitted bytes for the call. This information is available
when the event type is callCleared(3).
eventXmitRate
Negotiated transmitted baud rate used throughout the call. This
information is available when the event type is callCleared(3).
For IP fax, transmitted and received baud rates are the same.
eventDataRate
Negotiated received baud rate used throughout the call. This
information is available when the event type is callCleared(3).
For IP fax, transmitted and received baud rates are the same.
eventUserIPAddress
User’s IP address. This information is available when the event
type is nameChanged(5).
eventUserName
Username. This information is available when the event type is
callOriginated(1).
eventModemSlotNumber
Slot in which the modem is located. This information is avail-
able when the event type is callOriginated(1).
eventModemOnSlot
Modem in use. This information is available when the event
type is callOriginated(1).
ssnActiveUserName
Active username.
ssnActiveUserIPAddress
Active user’s IP address.
ssnActiveCurrrentService:
ipFax(19)
ipFax(19) service is in use for an outgoing IP fax call.
MIB field name
Reports