Encaps=comb, Encaps=fr and encaps=fr_cir, Encaps=comb -24 encaps=fr and encaps=fr_cir -24 – Lucent Technologies 6000 User Manual
Page 156

4-24
MAX 6000/3000 Network Configuration Guide
Configuring Individual WAN Connections
The Connection profile
CBCP Mode
CBCP Trunk Group
IPX Header Compression
Split Code.User
Encaps=COMB
When Connections > Connection profile > Encaps=PPP, the following parameters appear in
the interface for Ethernet > Connections > Connection profile > Encaps Options:
Ethernet
Connections
Connection profile
Password Reqd
Send PW
Recv PW
Interval
Base Ch Count
Compression
Password Reqd
Whether a password will be required to authenticate the Combinet connection.
Interval
Number of seconds between the receipt or transmission of Combinet line-integrity packets. If
the MAX unit does not receive a Combinet line-integrity packet within three of these intervals,
it disconnects the call.
Compression
Whether data compression is on or off for a Combinet link. Both sides of the link must enable
compression for the algorithm to have any effect.
Encaps=FR and Encaps=FR_CIR
When Connections > Connection profile > Encaps=FR and when Connections > Connection
profile > Encaps=FR_CIR, the following parameters appear in the interface for Ethernet >
Connections > Connection profile > Encaps Options:
Parameter
Specifies
FR Prof
Name of the Frame Relay profile to use for forwarding this link on the
Frame Relay network.
DLCI
Frame Relay Data Link Connection Indicator (DLCI) number for a
gateway or circuit connection. A DLCI is a number between 16 and
991, which is assigned by the Frame Relay administrator. A DLCI is
not an address, but a local label that identifies a logical link between a
device and a Frame Relay switch. The switch uses the DLCI to route
frames through the network, and the DLCI may change as frames are
passed through multiple switches.