Linksys BEFN2PS4 - Manual (Page 19)

EtherFast ® Cable/DSL & Voice Router powered by Net2Phone
Static Routing
If your Router is connected to more than one network, it may be necessary to
set up a static route between them. A static route is a pre-determined pathway
that network information must travel to reach a specific host or network.
Click the Show Routing Table button to view the current static routing con-
figuration.
To create a static route entry:
1. Select Static Route Entry from the drop down list. The Cable/DSL
Router supports up to 20 static route entries.
2. Enter the following data to create a new static route:
Destination LAN IP The Destination LAN IP is the Address of the remote
network or host to which you want to assign a static route. Enter the IP
address of the host for which you wish to create a static route here. If you
are building a route to an entire network, be sure that the network portion
33
Static Routing
32
Instant Broadband TM Series
Dynamic Routing
With Dynamic Routing you can automatically adjust to physical changes in
the network's layout. The router, using the RIP protocol, determines the net-
work packets’ route based on the fewest number of hops between the source
and the destination. The RIP protocol regularly broadcasts routing informa-
tion to other routers on the network. To set up Dynamic Routing:
1. Choose the correct working mode. Gateway Mode should be used if your
Linksys router is hosting your network's connection to the Internet.
Router Mode should be selected if the router exists on a network with
other routers.
2. In the TX field, choose the protocol by which you transmit data on the
network.
3. In the RX field, choose the protocol by which the Router receives net-
work data.
4. Click the Apply button to save your changes.
Dynamic Routing