Linksys WAG54G - Manual (Page 15)

8 Chapter 3: Getting to Know the Wireless-G ADSL Gateway
The Back Panel
Wireless-G ADSL Gateway
Chapter 3: Getting to Know the Wireless-G ADSL Gateway
The Back Panel
The Gateway’s ports, where a network cable is connected, are located on the back panel.
ADSL The ADSL port connects to the ADSL line.
LAN (1-4) The LAN (Local Area Network) ports connect to your computer and other network devices.
Power The Power port is where you will connect the power adapter.
Reset Button There are two ways to Reset the Gateway's factory defaults. Either press the Reset Button,
for approximately ten seconds, or restore the defaults from the Factory Defaults screen of the
Administration tab in the Gateway’s Web-Based Utility.
With these, and many other, Linksys products, your networking options are limitless. Go to the Linksys website at
www.linksys.com for more information about products that work with the Gateway.
Important: Resetting the Gateway to factory
defaults will erase all of your settings (WEP
Encryption, Wireless and LAN settings, etc.)
and replace them with the factory defaults. Do
not reset the Gateway if you want to retain
these settings.
Figure 3-1: Back Panel