LG LST-4200A User Manual
Page 12
12
Connections (Continued)
HD Monitor Component (YPbPr) Connections
11
Connect the “Antenna/Cable” to the “ANT IN” jack on the HDTV Receiver using a coaxial RF cable.
ote
There might be some areas where the signal strength could be too high. If so, you may need to connect the
antenna to an attenuator. Screw the attenuator onto the “ANT IN” jack. (Refer to page 10.)
2
2
Connect the “ANT LOOP OUT” jack from the HDTV Receiver to the “Antenna In” jack on your TV using a coaxi-
al RF cable.
3
3
Connect the “COMPONENT OUT” jacks from the HDTV Receiver to the “COMPONENT IN” jacks on your TV
using RCA-type cables. (The Output Selection must be set to YPbPr, refer to Display Format Setup on page
17.)
4
4
Connect the L/R “AUDIO OUT” jacks from the HDTV Receiver to the L/R “AUDIO IN” jacks on your TV using
RCA-type cables.
ote
1080i, 720p, 480p, and 480i modes are available for component video (YPbPr) outputs.
Y
Pb
Pr
COMPONENT VIDEO INPUT
L
R
AUDIO INPUT
VIDEO
INPUT
ANTENNA
INPUT
Cable TV
Wall Jack Panel
OR
HD Ready TV Connection Panel
HDTV Receiver Connection Panel
Antenna
To AUDIO OUT