LevelOne GNS-8000 - Manual (Page 22)

21
• Deny Access
Denies all files access on the network share.
System Tools
The following system tools allow optimized maintenance or management of your LevelOne
NAS:
• SNMP Settings
In order to use Simple Network Management Protocol (SNMP) to manage the LevelOne
NAS's network components, the SNMP service must be started.
• Alert Notification
Configures administrator’s e-mail address and SMTP server IP address. In case of
warning or malfunction, an email is automatically sent to the administrator.
• Restart / Shutdown
Powers off or restarts the LevelOne NAS.
• Hardware Settings
You can enable or disable the following hardware functions of your LevelOne NAS:
1. Enable LCD panel setting function
The default is enabled. Allow you to change the TCP/IP configuration using the
LCD panel buttons.
2. Enable configuration reset switch
The default is enabled. Depress and hold on the configuration reset switch for 5
seconds to reset the administrator password and network settings to the factory
default.
3. Enable hard disk standby mode
The default is enabled. Hard disk will go to standby mode if there is no access within
the period you specify.
4. Enable buzzer
Default setting is enabled. If the buzzer is disabled, it will not sound when a system
error occurs, but the warning light will still shine.
• UPS (For GNS-8000 Only)
The LevelOne NAS is equipped with a serial port interface to support UPS
(uninterrupted power supply) connection. By connecting the UPS to the serial port
and enabling the UPS support, you can protect the system from abnormal shutdown
caused by power outage. In the event of utility power failure, the system will shut
down automatically by probing the power status of the connected UPS unit. You can
also set a shutdown timer to power off the system automatically after it detects the
AC power failure. In general, the UPS can keep supplying the power for the system
for about 5 to 10 minutes. But this depends on the maximum load of the UPS and the
number of the loads connected to it.
If the UPS you used is not supported, please contact technical support or visit our
web site for updated news.
• System Update
Performs system software updates. Make sure that the image file that you are about to