Before using clean&charge, Operating your clean&charge – Braun 7680 User Manual
Page 12
12
Before using Clean&Charge
For the first charge of the shaver, connect the power
supply cord set directly to the shaver, charge it for
4 hours and shave at least once.
Only then can the shaver be cleaned or recharged in the
Clean&Charge.
If the rechargeable batteries are discharged, select the
combined «clean + charge» program rather than the
«clean» program alone.
Installing the cartridge
• Press the lift button (12) to open the housing.
• Hold the cartridge down on a flat, stable surface
(e.g. table). Carefully remove the lid from the cartridge.
Slide the cartridge into the base as far as it will go.
• Slowly close the housing by pushing it down until it
locks.
Replacing the cartridge
After having pressed the lift button to open the housing,
wait for a few seconds before removing the used
cartridge.
Before discarding the used cartridge, make sure to close
the openings using the lid of the new cartridge, since the
used cartridge will contain contaminated cleaning
solution.
Operating your Clean&Charge
Use the power supply cord set from your shaver and
plug it into the Clean&Charge and then into a main outlet.
Open the contact bow (13) by pressing the release
button (14). After shaving, switch the shaver off and
place it upside down into the Clean&Charge (without
having released the shaver foil).
• Select the operation mode by toggling with the mode
selector (15):
clean
(about 15 min)
clean + charge (about 75 min)
charge
(about 60 min)
The corresponding lights will come on.
(With cord shavers, only the «clean» function can be
selected.)
2
1
old
new
new
7680
a
u
to
m
a
tic
lo
ck
3
2
1
0
a
u
to
m
a
tic
lo
ck
3
2
1
0
on/o
ff
cle
an
ch
arg
e
car
trid
ge
7680
7680
5491427_S 4-38 Seite 12 Donnerstag, 20. Dezember 2001 12:30 12