LevelOne FBR-1402TX - Manual (Page 39)

LevelOne Broadband Router User Guide
Macintosh Clients
From your Macintosh, you can access the Internet via the LevelOne Broadband Router. The
procedure is as follows.
1. Open the TCP/IP Control Panel.
2. Select
Ethernet from the Connect via pop-up menu.
3. Select Using DHCP Server from the Configure pop-up menu. The DHCP Client ID field
can be left blank.
4. Close the TCP/IP panel, saving your settings.
Note:
If using manually assigned IP addresses instead of DHCP, the required changes are:
• Set the Router Address field to the LevelOne Broadband Router's IP Address.
• Ensure your DNS settings are correct.
Linux Clients
To access the Internet via the LevelOne Broadband Router, it is only necessary to set the
LevelOne Broadband Router as the "Gateway".
Ensure you are logged in as "root" before attempting any changes.
Fixed IP Address
By default, most Unix installations use a fixed IP Address. If you wish to continue using a
fixed IP Address, make the following changes to your configuration.
• Set your "Default Gateway" to the IP Address of the LevelOne Broadband Router.
• Ensure your DNS (Name server) settings are correct.
To act as a DHCP Client (recommended)
The procedure below may vary according to your version of Linux and X -windows shell.
1. Start your X Windows client.
2. Select
Control Panel - Network
3. Select the "Interface" entry for your Network card. Normally, this will be called "eth0".
4. Click
the Edit button, set the "protocol" to "DHCP", and save this data.
5. To apply your changes
• Use the "Deactivate" and "Activate" buttons, if available.
• OR, restart your system.
Printing Setup on Linux (FBR-1403TX only)
The LevelOne Broadband Router supports LPD Printing on Linux.
• The LevelOne Broadband Router supports 3 "Logical Printers" under LPD. To configure
the "Logical Printers" on the LevelOne Broadband Router, refer to Printer Port in Chapter
7.
• The procedure to install a LPD printer is detailed below, but may vary according to your
version of Linux and X -windows shell.
1. In your X Windows shell, select Control Panel, then Printer Configuration.
36