Lathem Sonachron DWA-S - Manual (Page 7)

Page 4
9. Secure unit to wall using screws (not provided).
Step 2 – Swith Off Power to AC Circuit
1. SWITCH OFF THE CIRCUIT THAT WILL FEED AC POWER
TO THE UNIT BEFORE PROCEDING.
Step 3 – Connect Wires for 115VAC or 24VAC Bells
IMPORTANT! This unit is shipped from the factory as a Bell
Ringer. To change to an ON/OFF controller, see DIP Switch
Setting on page 8. This section provides instructions for
wiring 115VAC or 24VAC bells, see Wiring Diagrams on
pages 20 – 22 for other options.
1. There are three options for routing wires into the DWA-S:
top, back or bottom. Select on of these and remove the plug.
2. Remove cover from terminal strip.
Drill Holes
Wall
Anchor