Lathem Sonachron DWA-S - Manual (Page 12)

Page 9
PROGRAMMING A SECURITY CODE
Upon power up you are allowed to enter a security code to
restrict access to programming functions. When the unit
displays “SECURITY CODE”, press from one to four Day of the
Week keys. This is your security code. The ERASE EVENT key
can be used to clear the code for re-entry. Press the RUN key to
advance the programming when you are satisfied with the
security code. The unit will prompt “UNSECURED MANUAL
FWD TO CHANGE.” If this selection is chosen, only the
programming functions will require the security code to be
accessed. MANUAL, START LUNCH, and START BREAK will
be unsecured. Pressing the selection requires the security code
to be entered prior to both accessing the programming functions
and using the MANUAL, START LUNCH, and START BREAKS
keys. The remote START LUNCH and START BREAK
switches do not require the security code to activate Lunch or
Break schedules. After choosing the level of security desired,
press the RUN key to advance to the normal display.
If unlimited access to all functions is desired (no security), press
the RUN key without pressing any Day of the Week keys when
the unit prompts for the security code. The unit will advance to
the normal display and no security code will be required to
access any function.
To change or view the security code, remove the left side panel,
toggle Dip Switch 2, and return it to the desired position. The
current security code will be displayed. Replace the side panel.
To change the code, press the ERASE EVENT key to clear the
current code and program the new code in the same manner as
described above. If you do not wish to change the code, press
the RUN key until the normal display returns.