LCD Digital DGP2-641 - Manual (Page 7)

LCD Keypad 7
3.7 ONE-TOUCH BUTTONS
If enabled by your Installer, you can access the following features without using your User Access Code by pressing
and holding the desired One-Touch button.
3.8 KEYSWITCH ARMING
A key can be used to arm and disarm your system using two forms of keyswitches. With a Maintained Keyswitch,
place the key in the “ON” position to arm your system, and place the key in the “OFF” position to disarm your
system. With a Momentary Keyswitch, place the key in the “ON” position briefly then place it back in the “OFF”
position to arm the system. Repeat this process to disarm with a Momentary Keyswitch.
3.9 AUTO-ARMING
If enabled by your Installer, you can set the time that an area will arm itself automatically.
3.9.1 T IMED A UTO -A RMING
Your installer can set Timed Auto-Arming to function in either Force or Stay arming mode. A sixty-second
Exit Delay sequence will begin prior to your system automatically arming itself at the programmed time.
1. Enter your [ ACCESS CODE ].
2. Press the [0] button.
3. Press the [
MEM ] button.
4. If you have access to more than one area, press the area’s number, or use the [
S] and [T] buttons
and press the [ ACC ] button when the area you want to program appears on the screen.
5. Enter the time you want the area to be armed according to the 24-hour clock (i.e. 9 a.m. is 09:00 and
9 p.m. is 21:00).
6. Press the [ ENTER ] button to save and exit.
3.9.2 N O M OVEMENT A UTO -A RMING
Your system can be programmed to send a report to your Central Monitoring Station and/or arm the
system if there is no activity in the area during a specified period of time. Your installer can set No
Movement Auto-Arming to function in either Regular or Stay arming mode.
4.0 DISARMING
When your system is disarmed, it deactivates any alarms in progress, and it deactivates the zones so the alarm will
not be triggered if zones are breached.
4.1 ENTRY DELAY TIMER
Your installer will program designated entry points (i.e. the front door) with an Entry Delay Timer. This delay gives
you time to enter the armed premises and enter your code to disarm your system before the alarm is triggered.
4.2 DISARMING AN ARMED SYSTEM
You can only disarm an area to which your User Access Code is assigned. User Access Codes with the “Arm Only”
(section 5.4 on page 11) option enabled cannot disarm an armed system.
Tp Disarm the system:
1. Enter your [ ACCESS CODE ].
2. Press the [ DISARM ] button. If you have access to more than one area, select the area(s) you wish to disarm
(refer to section 2.3 on page 5).
BUTTON FEATURE BUTTON FEATURE
[ ARM ] Regular arm [ DISARM ] Disarm a Stay/Instant armed area
[ STAY ] Stay arm [5] Instant arm
[ FORCE ] Force arm [6] Change display settings
[ BYP ] Bypass Programming [7] View Event Record display