LG LDX-514 - Manual (Page 13)

13
Preparation
RF coaxial connection
Connect the RF.OUT jack on the DVD+VCR to the
antenna in jack on the TV using the supplied 75-ohm
Coaxial Cable (R).
How to set the DVD+VCR’s RF output
channel
1. When the DVD+VCR is turned off, press and hold
CH (V/v) on the front panel for more than five
seconds. “RF03” or “RF04” appears in the display
window.
2. Press CH (V/v) to change the RF output channel
(RF03 or RF04). Tune the TV to this channel.
3. Turn off the DVD+VCR.
Audio/Video connection
1. Connect the DVD/VCR VIDEO OUT jack on the
DVD+VCR to the video in jack on the TV using
the video cable supplied (V).
2. Connect the Left and Right DVD/VCR AUDIO
OUT jacks on the DVD+VCR to the audio left/right
in jacks on the TV (A1) using the supplied audio
cables.
Notes:
• If you use this connection, set the TV’s source selector
to VIDEO.
• For DVD/VCR VIDEO OUT jack connection, resolution
must be set to 480i or 480p by pressing RESOLUTION
on the front panel, however DVD/VCR VIDEO OUT is
always at 480i standard resolution.
• HDMI mode must be set to OFF for DVD/VCR VIDEO
OUT jack connection.
Optional TV Connections Optional TV Connections
These connections support only DVD playback. The
tuner and VCR still output through the RF.OUT (R) or
DVD/VCR OUT (A, V) jacks.
S-Video connection
Connect the S-VIDEO OUT jack on the DVD+VCR
to the S-Video in jack on the TV using the optional
S-Video cable (S).
Notes:
• For S-Video connection, resolution must be set to
480i or 480p by pressing RESOLUTION on the
front panel, however S-VIDEO OUT is always at
480i standard resolution.
• HDMI mode must be set to OFF for S-Video
connection.
Component Video / Progressive Scan
connection
If your television is a high-definition or “digital ready”
television, you may take advantage of the
DVD+VCR’s progressive scan output for the highest
video resolution possible.
Connect the COMPONENT/PROGRESSIVE SCAN
VIDEO OUT jacks on the DVD+VCR to the corre-
sponding in jacks on the TV using an optional Y Pb
Pr cable (C).
Notes:
• You can change the resolution (480i, 480p, 720p, 1080i)
for the component/progressive scan video output by
pressing RESOLUTION on the front panel.
• For 720p and 1080i resolution, only non-copy protected
discs can be played back. If the disc is copy protected, it
will be auto down-scaling to 480p resolution.
• HDMI mode must be set to OFF for Component video
connections.
• Progressive scan does not work with the analog video
connections (yellow VIDEO OUT jack and S-VIDEO
OUT jack).
Audio connection
Connect the Left and Right AUDIO OUT jacks of the
DVD+VCR to the audio left/right in jacks on the TV
using the supplied audio cables (A2).