LOREX Technology L15LD400 - Manual (Page 36)

36
Record Setup
Record Setup - Schedule Setup
1. CHANNEL - Select a single channel to setup the
schedule.
2. TYPE - Select a recording mode:
• Continuous Recording: Recording is
constantly occurring.
• Motion: Begins the recording when motion is
detected.
• Alarm: Begins the recording when an alarm
is detected
• Motion and Alarm: Sets the system to
record when Motion and/or an Alarm is
detected.
3. 0~24 Hour - Activate or deactivate the schedule
for a particular hour in a week.
4. SUN~SAT - Activate or deactivate the scheduled
hours in a day. All hours in the day can be activated
or deactivated by double clicking on the name of
the day (i.e. Mon., Tue etc.).
NOTE: If the DVR is set to MOTION RECORDING
and the DVR keeps recording continuously or is not
triggered to record as expected, please check the
sensitivity settings and the motion mask setup in
CONFIGURATION>MOTION SETUP.
If the motion settings are too sensitive, you may
want to lower the sensitivity level and define a
motion detection area for more accuracy. If the
motion is not triggered as expected, you may want
to increase the sensitivity level, clear the motion
mask, or enlarge the detection area.