Linksys EG24M - Manual (Page 32)

10/100 Managed 24-Port GigaSwitch
BRIDGING
If you select Bridging from the Advanced Management screen, the following
Bridging Parameters screen will appear.
1. To change the aging time, highlight Aging Time and press
Enter. The following prompt will ask you to enter a bridge aging period,
in seconds. Enter a new aging period and press the Enter key. Enter 0 for
no aging.
2. To change the flood limit for all ports, highlight Flood Limit for All ports
, the following prompt will ask you to enter the flood limit,
in packets per second. Enter a a new flood limit and press the Enter key.
Enter 0 for no limit.
3. Press the Esc key until you return to the desired screen.
57
Linksys EtherFast ® II Series
5. Type a packet count number from 1 to 999, or type 0 for an infinite packet
count. Press Enter.
6. Move to Size and press Enter. The Enter Packet Size screen
will appear.
7. Type the packet size, from 0 to 1500, then press Enter.
8. Move to Timeout and press Enter. The Enter Timeout screen will
appear.
9. Type a timeout value, from 0 to 999, and press Enter.
10. When you finish specifying the ping parameters, press Esc to start ping-
ing a remote IP address.
11. Press Esc again to return to the L3 IP Networking screen.
56