Linksys EF1324 - Manual (Page 61)

EtherFast ® Layer 3 Management 24-Port 10/100 + 2-Port Gigabit Ethernet Switch
Troubleshooting
This section provides possible solutions to problems regarding the installation
and operation of the Managed 24-Port with Dual Gigabit Switch. If your situ-
ation is described here, the problem should be solved by applying the corre-
sponding solution. If you can’t find an answer here, check the Linksys website
at www.linksys.com.
1. I can’t connect to the Managed 24-Port with Dual Gigabit Switch using the
telnet, Web browser, or SNMP software.
• Be sure you have configured the agent with a valid IP address, subnet mask,
and default gateway (Layer 2).
• Check that you have a valid network connection to the Switch and that the
port you are using has not been disabled.
• Check the network cabling between the management station and the Switch.
• If you cannot connect using telnet, there may already be four active sessions.
Try connecting again at a later time.
2. I forgot or lost the password.
• Reinstall the switch firmware as described in the Appendix. Otherwise, con-
tact Linksys Technical Support for help.
115
Instant EtherFast ® Series
The Exit command under the Main Menu is used to exit the configuration pro-
gram and terminate communications with the Switch for the current session.
If you need to return to the program, press Enter repeatedly.
114
Common Problems and Solutions
Exit