Life Fitness Club Series Treadmill - Manual (Page 41)

T
ROUBLESHOOTING THE
T
READMILL ( CONTINUED )
Malfunction Probable Cause Corrective Action
Striding belt slips off-center. Floor surface is uneven.
Check levelers and level treadmill.
Check striding belt & re-tension as
necessary. Refer to How to Adjust and
Tension the Striding Belt.
Maximum speed is reduced.
User is pushing striding belt. This oc-
curs when the runner is running faster
than the striding belt will travel, with
the result of the striding belt being
pushed with the runner’s feet.
Instruct users not to push striding belt
in either direction.
User is stalling striding belt.This will
occur with heavier users at lower strid-
ing belt speeds. The striding belt will
“stall” if the user is traveling slower
than the striding belt speed.
Striding belt/deck malfunctions. The
deck laminate is worn through or the
underside of striding belt is glazed
over (hard, glossy).
Replace belt and deck.
Power source is insufficient. Plug treadmill into a 15 amp. circuit.
Rubbing sound comes from
underneath machine. Foreign objects may be stuck under-
neath the machine.
Inspect underneath striding belt and
machine. Remove any debris or
objects that may cause interference
with the treadmill.
Display does not illuminate when
machine is powered on. Loose 10 pin connection at display
console or DSP motor control board.
Check all electrical connections for
proper attachment. Contact Life
Fitness Customer Support Services.
40