Life Fitness Club Series Treadmill User Manual

Page 12

ERVICE

CCESS

ORT

The two interchangeable type RJ45 networking ports (A) are located on the back of the display
console. These network ports, located behind the display console rear access door, allow for console
software updates.

OWER

ORD

OUTING

The power cord can be run straight from the treadmill, shortened and exited out the user-front left side, or run under the
frame using the power cord clips and exited out the user right-rear side of the treadmill.

For efficient cord management, the following routing options are recommended:

With the power cord unplugged, insert the clips in the appropriate holes. See the illustration below. Use Hole Pattern 1 or
2 to locate the clips and secure the power cord with the clips, taking up any slack between clips.

Note: It may be necessary to tip the treadmill to route the power cord properly.

To plug the power cord into an outlet in front of the treadmill, use Hole Pattern 1 for outlets located at the front of the
machine.

Note: To accommodate treadmill incline, at least two feet (24”) of power cord is required between the outlet and the last
power cord clip for outlets in front of the treadmill.

To plug the power cord into an outlet in rear of the treadmill, use Hole Pattern 2 for outlets located at the rear of the
machine.

WARNING: Make sure that there is a 6.5 foot clearance behind the treadmill. Contact Life Fitness
Customer Services for an optional longer power cord if necessary.

WARNING: Insure that the power cord (A) does not contact the
striding belt or get pinched between the frame (C), lift arm (B) or the
wheel. Failure to follow this warning may result in serious injury.

AVERTISSEMENT : S'assurer que le cordon d'alimentation n'entre
pas en contact avec le tapis et ne soit pas pincé entre le cadre, le
bras de levage ou la roue. Le non-respect de cet avertissement peut
provoquer de graves blessures.

NOTE: When using Pattern 1, it is extremely important to route the power cord
BETWEEN the lift frame and the main frame.