Factory defaults, Setting up your computer¡¦s ip address, 2 setting up your computer’s ip address – Little Wonder ZyAIR G-4100 User Manual
Page 6: 4 factory defaults
ZyAIR G-4100
6
Table 2 Front Panel LEDs
LED STATUS
DESCRIPTION
ZyAIR
On (Blue)
The ZyAIR is ready, but is not sending/receiving data through the wireless
LAN.
Blinking (Blue)
The ZyAIR is sending/receiving data through the wireless LAN.
LAN (1-4)
On (Green)
The port is connected to a 10/100Mbps Ethernet device.
Blinking (Green)
The port is receiving or sending data.
Off
The port is not connected to a 10/100Mbps Ethernet device.
WAN
On (Green)
The WAN port has a connection to your cable or DSL modem.
Blinking (Green)
The WAN port is sending or receiving packets.
Off
The WAN link is not ready, or has failed.
SYS
On (Green)
The ZyAIR is ready and running.
Off
The ZyAIR is not ready or has failed.
PWR
On (Green)
The ZyAIR is receiving power.
Off
The ZyAIR is not receiving power.
1.4 Factory Defaults
Table 3 Factory Defaults
Username
“admin” (case sensitive)
WAN IP Address
DHCP Client (dynamic WAN IP)
Password
“1234”
LAN IP Address
192.168.1.1
LAN
DHCP
Server
2 Setting Up Your Computer’s IP Address
Skip this section if your computer is already set up to accept a dynamic IP
address. This is the default for most new computers.
The ZyAIR is already set up to assign your computer an IP address. Use this section to set up your
computer to receive an IP address or assign it a static IP address in the 192.168.1.2 to 192.168.1.254