Handset display, Line status indicators, Msg on – Lucent Technologies MDW 9030P User Manual
Page 3

Handset Display
MSG
ON
RANGE
MUTE
1
2
8
7
6
9
5
4
3
Each line status indicator corresponds to a specific outside line or
programmable/intercom/drop button:
PARTNER Systems
A
triangle
(
) is the equivalent of a green LED on a wired phone.
A
rectangle
( ) is the equivalent of a red LED on a wired phone.
All Other Systems
A
triangle
(
) is the equivalent of a red LED on a wired phone.
A
rectangle
( ) is the equivalent of a green LED on a wired phone.
Line Status Indicators
1
Information you would see on a wired system phone's display,
(except time), based on your communications system:
LCL:P, D, M1,
or
M2
= Local Mode:communications system
WIRELESS TEST
=Handset in Wireless Test Mode
VIBR
=Vibrator enabled
PSEL
=Line Preselection enabled
PRESELECTION:ON / OFF
=Line Preselection Mode:status
CHANGE BUTTN MAP
=Communications system setting is wrong
MAP:P, D, M1, M2
=Button Mapping Mode: setting
NO LINK
=Handset is not communicating with radio module
2
MSG
indicates that you have a message.
3
RANGE
indicates that the handset is out of range or almost out of
range. Handset also beeps.
4
ON
indicates that handset was turned on by pressing O
.
5
Battery
icon flashes to indicate a low battery condition. Handset
also emits 2 beeps.
6
No Ring
icon indicates that the alerter is disabled.
7
MUTE
indicates that handset microphone was turned off by
pressing M.
8
Line Status Indicators
show the status of line or programmable/
intercom/drop buttons. See "Line Status Indicators" below.
9
Selection rectangle
indicates the active row for line or program-
mable/intercom/drop button selection.
When the display is blank, the handset is either turned off or in "sleep"
mode. Activate the display by pressing O or ".
- 2 -
9030P QuickRef Fin. Drft.
2/7/97, 1:27 PM
4