Little Wonder 900 - Manual (Page 10)

7
ILLUSTRATED INSTRUCTIONS
FOR MAINTENANCE
Warning
Before any maintenance or adjustment to
BedShaper
® is performed, always remember to:
stop engine. Disconnect spark plug wire and
allow components to cool before servicing.
Clean Blade Shield:
1. Make sure blade is cool.
2. Remove two cover bolts from blade shield.
Open hinged shield.
3. Remove debris from shield and behind blade
with a dowel or similar object. Never use hand-
blade may be sharp.
4. Close shield back into position. Securely fasten
shield with two bolts. Never operate without
shield securely fastened.
BedShaper ® Maintenance Chart- Service Intervals
Item Daily 25 Hrs. Yearly Page
Visual Inspection ■
Engine Refer to Engine Manual
Clean Blade Shield ■ 6
Check Wear on Blade ■ 7
Lubricate Blade Arm Zerk Grease Fittings ■ 7
Check Drive Belts ■ 8
Lubricate Blade Shaft & Axle Bearings ■ 8
Chain Tension ■ 8
End of Season Cleaning ■ 8
Table 5-1
Section 5
MAINTENANCE
Little Wonder ®