LG PCS100R - Manual (Page 4)

4
206-4142
(Continued from previous page)
21. Damage Requiring Service
Unplug this product from the wall power out-
let and refer servicing to qualified service
personnel under the following conditions:
a. If the power-supply cord or plug is damaged.
b. If liquid has been spilled, or objects have
fallen into the product.
c. If the product has been exposed to rain or
water.
d. If the product does not operate normally
by following the operating instructions.
Adjust only those controls that are covered
by the operating instructions, as an
improper adjustment of other controls may
result in damage and will often require
extensive work by a qualified technician to
restore the product to its normal operation.
e. If the product has been dropped or the
cabinet has been damaged.
f. If the product exhibits a distinct change in
performance.
22. Servicing
Caution: These servicing instruc-
tions are for use by qualified service
personnel only. To reduce the risk
of electrical shock, do not perform any
servicing other than that described in the
operating instructions unless you are
qualified to do so.
23. Replacement Parts
When replacement parts are required, be
sure the service technician uses replacement
parts specified by the manufacturer or that
have the same characteristics as the original
parts. Unauthorized substitutions may result
in fire, electric shock, or other hazards.
24. Safety Check
Upon completion of any service or repairs to
this product, ask the service technician to
perform safety checks to determine that the
product is in proper operating condition.
PCS100R Rack Installation (also see pages 9
and 10)
To install the PCS100R in a rack:
• Carefully slide the PCS100R into a standard
19-inch equipment rack.
• When mounted in the rack, make sure appro-
priate hardware is used. ALL FOUR MOUNT-
ING SCREWS MUST BE USED.
• This equipment is not designed to support
other devices. Do NOT stack other equipment
on the top of the PCS100R.
• Rear cabling must be dressed and supported
so that the weight of the cabling is not a strain
on the PCS100R connectors.
• MOUNTING OF THE EQUIPMENT IN THE
RACK SHOULD BE SUCH THAT A HAZARD-
OUS CONDITION IS NOT ACHIEVED DUE TO
UNEVEN MECHANICAL LOADING.
Rack-mount Considerations
A. Elevated Operating Ambient
If installed in a closed or multi-unit rack
assembly, the operating ambient tempera-
ture of the rack environment may be greater
than room ambient. Therefore, consideration
should be given to installing the equipment in
an environment compatible with the maximum
ambient temperature (Tma) specified by the
manufacturer (see “Specifications” information
in this document).
B. Reduced Air Flow
Installation of the equipment in a rack should
be such that the amount of air flow required
for safe operation of the equipment is not
compromised. Do NOT stack other equipment
on the top of the PCS100R unit.
IMPORTANT SAFETY INSTRUCTIONS
Caution: Refer all servicing to qualified
service personnel.
(Continued on next page)